Home › BRAKE › BRAKE CONTROL › DOWNHILL ASSIST CONTROL SWITCH (for 4WD)

DOWNHILL ASSIST CONTROL SWITCH (for 4WD) > INSTALLATION

for Preparation Click here



1. INSTALL DOWNHILL ASSIST CONTROL SWITCH


    C165823E01
  1. Engage the 2 claws and install the downhill assist control switch.



    C165815E01
  1. Connect the downhill assist control switch connector.



2. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    B168372
  1. Connect the connector.

  1. Engage the 4 claws and 4 clips, and install the upper console panel sub-assembly.



3. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/ Smart Key System)


    B184681E01
  1. Apply protective tape to the areas shown in the illustration.

  1. Connect each connector.

  1. Engage the 10 claws and 8 clips, and install the center instrument cluster finish panel assembly.

    NOTICE:
    Do not the damage the instrument panel safety pad assembly and lower instrument panel finish panel sub-assembly.



4. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Smart Key System)


    B184679E01
  1. Apply protective tape to the areas shown in the illustration.

  1. Connect each connector.

  1. Engage the 10 claws and 8 clips, and install the center instrument cluster finish panel assembly.

    NOTICE:
    Do not the damage the instrument panel safety pad assembly and lower instrument panel finish panel sub-assembly.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (Click here)



6. CHECK FOR WARNING LIGHT AND INDICATOR LIGHT
(Click here)