SFI SYSTEM > READINESS MONITOR DRIVE PATTERN |
| PURPOSE OF READINESS TESTS |
| CATALYST MONITOR (AIR FUEL RATIO SENSOR TYPE) |

Preconditions
Drive Pattern
(1) Connect the Techstream to the DLC3.
(2) Turn the power switch on (IG).
(3) Turn the Techstream on.
(4) Clear the DTCs (if set) (Click here).
(5) Turn the power switch on (READY).
(6) Warm up the engine [A].
(7) Drive the vehicle at between 47 mph and 55 mph (75 km/h and 88 km/h) for at least 10 minutes [B].
Monitor Status
Check the Readiness Monitor status displayed on the tester.
If the status does not switch to Complete, extend the driving time.
| EVAP SYSTEM MONITOR (KEY OFF TYPE) |
Preconditions
The monitor will not run unless:
Monitor Conditions
Turn the power switch off and wait for 9.5 hours.
Monitor Status
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream or scan tool on.
Check the Readiness Monitor status displayed on the Techstream or scan tool.
If the status does not switch to Complete, restart the engine, make sure that the preconditions have been met, and then perform the Monitor Conditions again.
| AIR FUEL RATIO AND HEATED OXYGEN SENSOR MONITORS (FRONT AIR FUEL RATIO AND REAR HEATED OXYGEN SENSOR TYPE) |

Preconditions
Drive Pattern for front air fuel ratio sensor and heated oxygen sensor
(1) Connect the Techstream to the DLC3.
(2) Turn the power switch on (IG).
(3) Turn the Techstream on.
(4) Clear the DTCs (Click here).
(5) Turn the power switch on (READY).
(6) Warm it up until the engine coolant temperature reaches 75°C (167°F) or higher.
(7) Drive the vehicle at between 44 mph (70 km/h) and 55 mph (88 km/h) for at least 10 minutes.
(8) Accelerate the vehicle to 44 mph (70 km/h) or more by depressing the accelerator pedal for at least 10 seconds.
(9) Soon after performing step (8) above, release the accelerator pedal for at least 5 seconds without depressing the brake pedal in order to execute fuel-cut control.
(10) Allow the vehicle to decelerate until the vehicle speed declines to less than 6 mph (10 km/h).
(11) Repeat steps (8) through (10) above at least 3 times in one driving cycle.
Monitor Status
Check the Readiness Monitor status displayed on the tester.
If the status does not switch to Complete, make sure that the preconditions have been met, and then perform steps (5) through (11) in the Drive Pattern above.
| AIR FUEL RATIO AND HEATED OXYGEN SENSOR HEATER MONITORS (FRONT AIR FUEL RATIO AND REAR HEATED OXYGEN SENSOR SENSOR TYPE) |
Preconditions

Drive Pattern
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream or scan tool on.
Clear the DTCs (if set).
Put the engine in inspection mode (Click here).
Start the engine.
Allow the engine to idle for 10 minutes or more [A].
Drive the vehicle at 25 mph (40 km/h) or more for at least 2 minutes [B].