Home › BODY › SLIDING ROOF › SLIDING ROOF SYSTEM

SLIDING ROOF SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the sliding roof system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (LIN)*
    1. Using the Techstream, check if the multiplex communication system is functioning normally.

      Result:
      Result
      Proceed to
      LIN DTC is not output
      A
      LIN DTC is output
      B



    B.
    Go to LIN COMMUNICATION SYSTEM (Click here)
    A


    4.CHECK FOR DTC*
    1. Delete the DTCs (Click here ).

    2. Recheck for DTCs (Click here).

      HINT:
      If DTCs are detected frequently, replace the ECU.

      OK:
      DTC is not output.



    NG.
    Go to DIAGNOSTIC TROUBLE CODE CHART (Click here)
    OK


    5.PROBLEM SYMPTOMS TABLE

      Result:

      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 8
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List / Active Test (Click here)
      2. Terminals of ECU (Click here)
      3. On-vehicle Inspection (Click here)

    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END