Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the tire pressure warning system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble.

      HINT:
      It is important to collect as much specific information as possible from the customer to allow for a quick repair.


    NEXT


    3.ADJUST TIRE PRESSURE
    1. Turn the power switch off.

    2. Connect the Techstream to the DLC3.

    3. Turn the power switch on (IG) and turn the Techstream on.

    4. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

    5. Read the "ID Tire Inflation Pressure" values.

    6. Adjust all tire pressures to the standard values (Click here).

    7. Check the DATA LIST (Click here).

      HINT:
      1. It takes about 2 or 3 minutes to display the updated tire pressure data.
      2. If the problem is that the tire pressure decreases, wait until all of the tire pressure data is received by the ECU. If the data is received, the tire pressure warning light will turn off.

        Result:
        Condition
        Proceed to
        Tire pressure warning light remains on
        A
        Tire pressure warning light goes off
        B



    B.
    GO TO STEP 11
    A


    4.CHECK ECU CONNECTED TO CAN BUS*
    1. Check the ECUs connected to the CAN bus (Click here).

      Result:
      Condition
      Proceed to
      No malfunction appears
      A
      Malfunction appears
      B



    B.
    Go to CAN COMMUNICATION SYSTEM
    A


    5.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)*
    1. Check for DTCs (Click here).

      Result:
      Condition
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    Go to CAN COMMUNICATION SYSTEM
    A


    6.CHECK FOR DTC*
    1. Check for DTCs (Click here).

      Result:
      Result
      Proceed to
      DTC is output
      A
      DTC is not output
      B



    B.
    GO TO STEP 8
    A


    7.DTC CHART
    1. Refer to DIAGNOSTIC TROUBLE CODE CHART (Click here).


    NEXT

    GO TO STEP 10


    8.PROBLEM SYMPTOMS TABLE
    1. Refer to PROBLEM SYMPTOMS TABLE (Click here).


    NEXT


    9.CIRCUIT INSPECTION*
    1. Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE (Click here).


    NEXT


    10.REPAIR OR REPLACE
    1. Repair or replace parts based on the diagnosis result.


    NEXT


    11.CONFIRMATION TEST
    1. Check the DATA LIST to confirm that the tire inflation pressure has been received (Click here).


    NEXT

    END