Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source for the tire pressure warning ECU.

WIRING DIAGRAM


C147971E22


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform registration (Click here) of the transmitter IDs into the tire pressure warning ECU if the ECU has been replaced.

1.INSPECT FUSE (ECU-IG NO. 1)
  1. Remove the ECU-IG NO. 1 fuse from the instrument panel junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG NO. 1
    Always
    Below 1 Ω



NG
Go to step 4
OK


2.CHECK HARNESS AND CONNECTOR (ECU - BATTERY)


    E137004E39
  1. Disconnect the D33 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D33-1 (IG) - Body ground
    Power switch on (IG)
    11 to 14 V
    Power switch off
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (ECU - BODY GROUND)


    E137004E40
  1. Disconnect the D33 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D33-7 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ECU (Click here)  

4.CHECK HARNESS AND CONNECTOR (ECU - FUSE)


    E137004E39
  1. Disconnect the D33 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D33-1 (IG) - Body ground
    Always
    10 kΩ or higher



NG
REPLACE FUSE AND REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE FUSE