Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > REMOVAL

for Preparation Click here


NOTICE:
Before removing the tire pressure warning ECU, read the registered transmitter IDs of all wheels and write them down to use for re-registration of transmitter IDs (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and the LH side.



3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side.



4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B172999
  1. Disengage the 3 claws.

  1. Disengage the 2 guides and remove the No. 2 instrument panel under cover sub-assembly.



5. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY


    B168370
  1. Remove the 2 bolts <B> and 3 screws <E>.

  1. Disengage the 4 claws and 3 clips.

  1. Disconnect each connector and clamp, and remove the lower instrument panel sub-assembly.



6. REMOVE TIRE PRESSURE WARNING ECU


    C165671
  1. Remove the nut.



    C165672
  1. Disconnect the connector and remove the tire pressure warning ECU.