Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2191/91    Vehicle Speed Signal Error (Test Mode DTC)

for Preparation Click here


DESCRIPTION

The tire pressure warning ECU receives speed signals from the combination meter via CAN communication. This DTC is stored upon entering test mode, and cleared when a vehicle speed signal of 20 km/h (12 mph) is detected for 3 seconds or more. This DTC is output only in test mode.

DTC Code
DTC Detection Condition
Trouble Area
C2191/91
Speed sensor circuit malfunction
  1. CAN communication system
  2. Vehicle speed signal circuit
  3. Combination meter
  4. Tire pressure warning ECU

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.

1.CHECK CAN COMMUNICATION SYSTEM
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Enter the following menus:
    "Bus Check" from the "System Select" / "Communication Malfunction DTC" from the "Bus Check" screen

  1. Check the CAN communication system (Click here).



NG
CHECK AND REPLACE CAN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Turn the power switch off.

  1. Connect Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Check for DTCs.
    Result 
    Result
    Proceed to
    CAN system DTC is not output
    A
    CAN system DTC is output
    B



B
CHECK AND REPLACE CAN COMMUNICATION SYSTEM (Click here)
A


3.CHECK VEHICLE SPEED SIGNAL (DATA LIST)
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

  1. Check that the values indicated on the Techstream and on the combination meter are the same.

    Tire Pressure Monitor:

    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed
    Vehicle speed reading/
    min.: 0 km/h (0 mph)
    max.: 255 km/h (158 mph)
    Actual vehicle speed
    Speed indicated on the combination meter

    OK:
    The vehicle speed displayed on the Techstream changes depending on the actual vehicle speed.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE TIRE PRESSURE WARNING ECU (Click here)