Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P1606-308    Collision Detection

for Preparation Click here


DESCRIPTION

In the event of a collision, the hybrid vehicle control ECU receives a signal from the center airbag sensor assembly and/or circuit breaker sensor (front collision sensor) that indicates a collision. After a collision is detected, the hybrid vehicle control ECU shuts off the high-voltage systems for safety.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P1606
308
  1. Shutoff signal from the center airbag sensor assembly is determined
  2. Collision is determined by the signal from the circuit breaker sensor (front collision sensor)
  1. Center airbag sensor assembly
  2. No. 1 circuit breaker sensor
  3. Collision damage

HINT:
If P1606-308 is output, the hybrid system cannot be turned on unless the DTC is cleared using Techstream.


INSPECTION PROCEDURE

1.CHECK VEHICLE FOR COLLISION DAMAGE
  1. Check the vehicle condition.

    Result:
    Result
    Proceed to
    The vehicle is not damaged.
    A
    The vehicle is damaged.
    B



B
REPAIR VEHICLE
A


2.CHECK DTC OUTPUT (HV)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P1606 only is output.
    A
    P1606 and PA01D are output.
    B



B
GO TO DTC CHART (P0A1D) (Click here)
A


3.CHECK SUPPLEMENTAL RESTRAINT SYSTEM
  1. Troubleshoot the supplemental restraint system.

    Result:
    Result
    Proceed to
    The system is normal.
    A
    There is a malfunction in the system.
    B



B
REPAIR MALFUNCTIONING PARTS, COMPONENT AND AREA
A


4.CONFIRM INFORMATION (EXCLUSIVE INFO 1 TO 2)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Access the freeze frame data corresponding to DTC P1606 and select the information.

  1. Read "Specific Information" of the information of INF code 308.

    Result:

    Displayed item in exclusive information
    Proceed to
    Specific information 1 indicates -126.
    A
    Specific information 2 indicates -126.
    B



B
REPLACE NO. 1 CIRCUIT BREAKER SENSOR (Click here)
A

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)