Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    C1203/95    ECM Communication Circuit Malfunction

for Preparation Click here


DESCRIPTION

The circuit is used to send TRAC and VSC control information from the skid control ECU to the hybrid vehicle control ECU, and hybrid control information from the hybrid vehicle control ECU to the skid control ECU via the CAN communication system.

DTC Code
INF Code
DTC Detection Condition
Trouble Area
C1203/95
-
Any of the following is detected:
  1. No stored information for destination.
  2. No stored information whether VSC is in operation or not.
  3. Destination information from hybrid vehicle control ECU does not match with stored value.
Hybrid vehicle control ECU

INSPECTION PROCEDURE

1.CHECK PART NUMBER (SKID CONTROL ECU AND HYBRID VEHICLE CONTROL ECU)
  1. Check that the proper skid control ECU and hybrid vehicle control ECU are installed.

    OK:
    Proper ECUs are installed.



NG
REPLACE ECUS WITH PROPER ONES
OK


2.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Perform a road test.

  1. Check if the same DTC is recorded (Click here).

    Result:

    Result
    Proceed to
    DTC (C1203/95) is not output
    A
    DTC (C1203/95) is output
    B



B
REPLACE HYBRID VEHICLE CONTROL ECU (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)