Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    C1345/66    Linear Solenoid Valve Offset Learning Undone

DTC    C1368/67    Linear Solenoid Valve Offset Malfunction

for Preparation Click here


DESCRIPTION

The skid control ECU stores and corrects the difference in each individual part such as the stroke sensor, actuator solenoids, and stroke simulator solenoid. Perform initialization and calibration of the linear solenoid valve if these parts are replaced.
The skid control ECU receives shift position P signals from the hybrid vehicle control ECU through CAN communication system.
The DTCs are cancelled when the result of linear valve offset learning is normal.

DTC Code
INF Code
DTC Detection Condition
Trouble Area
C1345/66
501
Value of initialization and calibration of the linear solenoid valve for the FR wheel is not stored.
  1. Initialization and calibration of the linear solenoid valve undone
  2. Skid control ECU
↑
502
Value of initialization and calibration of the linear solenoid valve for the FL wheel is not stored.
↑
↑
503
Value of initialization and calibration of the linear solenoid valve for the RR wheel is not stored.
↑
↑
504
Value of initialization and calibration of the linear solenoid valve for the RL wheel is not stored.
↑
C1368/67
505
Value of initialization and calibration of the linear solenoid valve is not within the brake actuator's standard value.
  1. Initialization and calibration of the linear solenoid valve undone
  2. Skid control ECU

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization and calibration of the linear solenoid valve (Click here).

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Check that the DTCs (electronically controlled brake system and hybrid control system) are recorded (Click here for electronically controlled brake system, or Click here for hybrid control system).

    Result:

    Result
    Proceed to
    DTCs (except C1345/66, C1368/67 and hybrid control system DTC) are not output
    A
    Hybrid control system DTC is output
    B
    DTCs (except C1345/66 and/or C1368/67) are output
    C



B
INSPECT HYBRID CONTROL SYSTEM (Click here)

C
REPAIR CIRCUIT INDICATED BY OUTPUT DTC (Click here)
A


2.PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE
  1. Turn the power switch off.

  1. Perform initialization and calibration of the linear solenoid valve (Click here).


NEXT


3.RECONFIRM DTC
  1. Turn the power switch off.

  1. Clear the DTCs (Click here).

  1. Turn the power switch on (IG).

  1. Check if the same DTC is recorded (Click here).

    Result:

    Result
    Proceed to
    DTCs (C1345/66 and C1368/67) are not output
    A
    DTCs (C1345/66 and/or C1368/67) are output
    B



B
REPLACE SKID CONTROL ECU (Click here)
A

END