Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › OCCUPANT CLASSIFICATION SYSTEM

DTC    B1795    Occupant Classification ECU Malfunction

for Preparation Click here


DESCRIPTION

DTC B1795 is recorded when a malfunction is detected in the occupant classification ECU.
Troubleshoot DTC B1771 first if DTCs B1771 and B1795 are output simultaneously.

DTC No.
DTC Detection Condition
Trouble Area
B1795
  1. Front seat inner belt assembly RH malfunction
  2. Occupant classification ECU malfunction
  1. Front seat inner belt assembly RH
  2. Occupant classification ECU

HINT:
When DTC B1650/32 is detected as a result of troubleshooting for the AIRBAG SYSTEM, check the DTCs stored in the occupant classification ECU. When DTC B1795 is output, perform troubleshooting for the DTC.


INSPECTION PROCEDURE

1.CHECK DTC
  1. Turn the power switch on (IG), and wait for at least 10 seconds.

  1. Check for DTCs (Click here).

    Result:
    A:
    DTCs B1771 and B1795 are output.
    B:
    DTC B1795 is output.

    HINT:
    Codes other than DTCs B1771 and B1795 may be output at this time, but they are not related to this check.



A
GO TO DTC B1771 (Click here)
B


2.REPLACE OCCUPANT CLASSIFICATION ECU
  1. Turn the power switch off.

  1. Disconnect the negative (-) terminal cable from the battery.

  1. Replace the occupant classification ECU (Click here).


NEXT


3.PERFORM ZERO POINT CALIBRATION
  1. Connect the negative (-) terminal cable to the battery.

  1. Connect Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Using Techstream, perform "zero point calibration" (Click here).

    OK:
    "Zero Point Calibration is complete." is displayed.


NEXT


4.PERFORM SENSITIVITY CHECK
  1. Using Techstream, perform "sensitivity check" (Click here).

    Standard:
    27 to 33 kg (59.52 to 72.75 lb)


NEXT

END