DTC B1796 Sleep Operation Failure of Occupant Classification ECU |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1796 |
|
|
| 1.CHECK DTC |
Turn the power switch on (IG).
Clear the DTCs stored in the occupant classification ECU (Click here).
Clear the DTCs stored in the center airbag sensor assembly (Click here).
Turn the power switch off, and wait for at least 10 seconds.
Turn the power switch on (IG).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 2.REPLACE OCCUPANT CLASSIFICATION ECU |
Turn the power switch off.
Disconnect the negative (-) terminal cable from the battery.
Replace the occupant classification ECU (Click here).
| NEXT | |
| 3.PERFORM ZERO POINT CALIBRATION |
Connect the negative (-) terminal cable to the battery.
Connect Techstream to the DLC3.
Turn the power switch on (IG).
Using Techstream, perform "zero point calibration" (Click here).
| NEXT | |
| 4.PERFORM SENSITIVITY CHECK |
Using Techstream, perform "sensitivity check" (Click here).
| NEXT | ||
| ||