Home › ENGINE › 3MZ-FE LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL LEVEL
  1. Warm up the engine, turn the engine off and wait for 5 minutes. The oil level should be between the low level and full level marks of the dipstick.
    If low, check for leaks and add oil up to the full level mark.

    NOTICE:
    Do not fill with engine oil above the full level mark.



2. CHECK ENGINE OIL QUALITY
  1. Check for deterioration, traces of water, discoloring, or thinning.
    If the quality is visibly poor, replace the oil.



3. REMOVE FRONT FENDER APRON SEAL RH


    A108741
  1. Remove the 2 bolts, clip and fender apron seal RH.



4. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY


    A176034
  1. Disconnect the oil pressure switch connector.



    A176035
  1. Using a 24 mm deep socket wrench, remove the oil pressure switch.



5. INSTALL OIL PRESSURE GAUGE


    A111731E01
  1. Install an oil pressure gauge.



6. WARM UP ENGINE
  1. Set the vehicle to inspection mode. (Click here)

  1. Warm up the engine.



7. CHECK OIL PRESSURE
  1. Check the oil pressure. If the oil pressure is not as specified, check the oil pump (Click here).

    Standard oil pressure:

    Item
    Oil Pressure
    Idle
    29 kPa (0.3 kgf/cm2, 4.3 psi) or more
    3,000 rpm
    245 to 539 kPa (2.5 to 5.5 kgf/cm2, 36 to 78 psi)



8. REMOVE OIL PRESSURE GAUGE


9. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    A111734E01
  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



    A176036
  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine within 1 hour of installation.



    A176034
  1. Connect the oil pressure switch connector.



10. INSPECT FOR OIL LEAK


11. INSTALL FRONT FENDER APRON SEAL RH


    A108741
  1. Install the fender apron seal RH with the 2 bolts and clip.