Home › HYBRID SYSTEM · P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P2602-767    Coolant Pump Control Circuit Low

for Preparation Click here


DESCRIPTION

HINT:
Although the DTC title refers to "coolant pump", this DTC is related to the oil pump control circuit.

Refer to the description for DTC P2601-777 .

DTC No.
INF No.
DTC Detection Condition
Trouble Area
P2602
767
  1. GND short in oil pump circuit
  2. When OPM2 signal is on, OPST signal remains low
  1. Wire harness or connector
  2. Oil pump with motor assembly
  3. Hybrid vehicle control ECU

WIRING DIAGRAM

Refer to the wiring diagram for DTC P2601-777 .

INSPECTION PROCEDURE

NOTICE:
  1. When troubleshooting the oil pump with motor assembly, check for the following conditions:
    1. ATF temperature inside the oil cooler is 41°F (5°C) or more.
    2. The ambient temperature sensor value is 41°F (5°C) or more.

1.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - OIL PUMP WITH MOTOR ASSEMBLY)
  1. Disconnect connector A43 from the hybrid vehicle control ECU.

  1. Disconnect the oil pump with motor assembly connector.



    A175141E10
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A43-7 (OPST) - Body ground and other terminals
    Power switch off
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK OIL PUMP WITH MOTOR ASSEMBLY


    A175143E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A48-2 (OPST) - Body ground
    Power switch off
    10 kΩ or higher



NG
REPLACE OIL PUMP WITH MOTOR ASSEMBLY (Click here)
OK

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)