Home › SUSPENSION & AXLE › AXLE › AXLE SYSTEM

AXLE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST OF AXLE SYSTEM

HINT:
  1. Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
  2. The axle system is controlled by the brake control system (skid control ECU) and hybrid control system (HV control ECU). Therefore, the brake control system and hybrid control system can be checked by reading the Data List and performing the Active Test.
  1. - Electronically Brake Control System (Click here).
  2. - Hybrid Control System (Click here).

  1. Warm up the engine.

  2. Turn the power switch off.

  3. Connect the Techstream to the DLC3.

  4. Turn the power switch on (IG).

  5. Turn the Techstream on.

  6. Enter the following menus: Chassis / ABS/VSC/ TRAC / Data List.

  7. According to the display on the Techstream, read the Data List.


DATA LIST: ABS/TRAC/VSC 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
FR Wheel Speed
FR wheel speed sensor reading /
min.: 0 mph (0 km/h), max.: 202 mph (326.4 km/h)
Actual wheel speed
Similar speed as indicated on speedometer
FL Wheel Speed
FL wheel speed sensor reading /
min.: 0 mph (0 km/h), max.: 202 mph (326.4 km/h)
Actual wheel speed
Similar speed as indicated on speedometer
RR Wheel Speed
RR wheel speed sensor reading /
min.: 0 mph (0 km/h), max.: 202 mph (326.4 km/h)
Actual wheel speed
Similar speed as indicated on speedometer
RL Wheel Speed
RL wheel speed sensor reading /
min.: 0 mph (0 km/h), max.: 202 mph (326.4 km/h)
Actual wheel speed
Similar speed as indicated on speedometer

ACTIVE TEST OF AXLE SYSTEM

HINT:
  1. Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts to operate without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
  2. The axle system is controlled by the brake control system (skid control ECU) and hybrid control system (HV control ECU). Therefore, the brake control system and hybrid control system can be checked by reading the Data List and performing the Active Test.
  1. - Electronically Brake Control System (Click here).
  2. - Hybrid Control System (Click here).

  1. Warm up the engine.

  2. Turn the power switch off.

  3. Connect the Techstream to the DLC3.

  4. Turn the power switch on (IG).

  5. Turn the Techstream on.

  6. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  7. Check the operation by referring to the table below.


ACTIVE TEST: METER 
Tester Display
Test Part
Control Range
Diagnostic Note
Meter Display 1
Multi-information Display
All the dots in the multi-information display OFF/ON
Confirm that the vehicle is stopped, engine idling
Master Warning
Master Caution Indicator Light
Master caution indicator light is OFF/ON
Confirm that the vehicle is stopped, engine idling