Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Skid Control ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
Skid Control ECU Communication Stop Mode
  1. "ABS/VSC/TRC" is not displayed on "Communication Bus Check" screen of Techstream
  2. "Skid Control ECU Communication Stop Mode" in "DTC COMBINATION TABLE"
  1. Power source circuit of skid control ECU
  2. Skid control ECU branch wire or connector
  3. Skid control ECU

WIRING DIAGRAM


C176066E01


INSPECTION PROCEDURE

NOTICE:
  1. Turn the power switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the power switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, any other switches or the doors. If the doors need to be opened in order to check the connectors, open the doors and leave them open.

HINT:
  1. Operating the power switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.

1.CHECK CAN BUS WIRE FOR DISCONNECTION (SKID CONTROL ECU BRANCH WIRE)
  1. Turn the power switch off.

  1. Disconnect the skid control ECU connector.



    G032345E12
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A44-19 (CANH) - A44-18 (CANL)
    Power switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (SKID CONTROL ECU BRANCH WIRE)
OK


2.CHECK DTC OUTPUT
  1. Check for skid control ECU output DTCs (Click here).

  1. Read the DTCs.

    OK:
    C1241 is not stored.



NG
GO TO DTC CHART (C1241) (Click here)
OK

REPLACE SKID CONTROL ECU ASSEMBLY (Click here)