CAN COMMUNICATION SYSTEM > Open in CAN Main Bus Line |
| Symptom | Trouble Area |
| Resistance between terminals 6 (CANH) and 14 (CANL) of DLC3 is 70 Ω or higher. |
|

| 1.CHECK DLC3 |
![]() |
Turn the power switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D47-6 (CANH) - D47-14 (CANL) | Power switch off | 108 to 132 Ω |
|
| ||||
| OK | |
| 2.CHECK FOR OPEN IN CAN BUS MAIN WIRE (CAN JUNCTION CONNECTOR CTR) |
Turn the power switch off.
Disconnect the CAN junction connector CTR.
Measure the resistance according to the value(s) in the table below.

| Tester Connection | Connect to | Switch Condition | Specified Condition |
| D55-1 (CANH) - D55-12 (CANL) | CAN junction connector RH | Power switch off | 108 to 132 Ω |
| D55-6 (CANH) - D55-17 (CANL) | Combination meter | Power switch off | 108 to 132 Ω |
| Result | Proceed to |
| OK | A |
| NG (CAN junction connector main wire) | B |
| NG (Combination meter main wire) | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 3.CHECK FOR OPEN IN CAN BUS MAIN WIRE (COMBINATION METER) |
Reconnect the CAN junction connector CTR.
Disconnect the combination meter connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E1-25 (CANH) - E1-26 (CANL) | Power switch off | 108 to 132 Ω |
|
| ||||
| OK | ||
| ||
| 4.CHECK FOR OPEN IN CAN BUS MAIN WIRE (CAN JUNCTION CONNECTOR RH) |
Reconnect the CAN junction connector CTR.
Disconnect the CAN junction connector RH.
Measure the resistance according to the value(s) in the table below.

| Tester Connection | Connect to | Switch Condition | Specified Condition |
| D59-1 (CANH) - D59-12 (CANL) | Hybrid vehicle control ECU | Power switch off | 108 to 132 Ω |
| D55-5 (CANH) - D55-16 (CANL) | CAN junction connector CTR | Power switch off | 108 to 132 Ω |
| Result | Proceed to |
| OK | A |
| NG (Hybrid vehicle control ECU main wire) | B |
| NG (CAN junction connector) | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 5.CHECK FOR OPEN IN CAN BUS MAIN WIRE (HYBRID VEHCLE CONTROL ECU) |
Reconnect the CAN junction connector RH.
Disconnect the hybrid vehicle control ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D36-25 (CANH) - D36-33 (CANL) | Power switch off | 108 to 132 Ω |
|
| ||||
| OK | ||
| ||