NAVIGATION SYSTEM > Navigation Receiver Assembly Communication Error |
| 1.IDENTIFY THE COMPONENT SHOWN BY SUB-CODE |
![]() |
Enter the diagnostic mode.
Press the "LAN Mon" switch to change the mode to "LAN Monitor" mode.
Identify the component shown by the sub-code.
| NEXT | |
| 2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE |
Inspect the power source circuit of the component shown by the sub-code.
If the power source circuit is operating normally, proceed to the next step.
| Component | Proceed to |
| 1B0 (Television display assembly) | Television display assembly power source circuit (Click here) |
| 440 (Stereo component amplifier) | Stereo component amplifier power source circuit (Click here) |
| NEXT | |
| 3.CHECK NAVIGATION RECEIVER ASSEMBLY |
Disconnect the navigation receiver assembly connectors.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E15-9 (TXM+) - E15-10 (TXM-) | Always | 60 to 80 Ω |
| E2-5 (ATX+) - E2-15 (ATX-) | Always | 60 to 80 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMPONENT SHOWN BY SUB-CODE) |
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the navigation receiver assembly and the component shown by the sub-code.
Disconnect all connectors between the navigation receiver assembly and the component shown by the sub-code.
Check for an open or short in the AVC-LAN circuit between the navigation receiver assembly and the component shown by the sub-code.

|
| ||||
| OK | |
| 5.REPLACE COMPONENT SHOWN BY SUB-CODE |
Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.
|
| ||||
| OK | ||
| ||