DTC C2176/76 Receiver Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| C2176/76 | Any of the following is detected:
|
|

| 1.CHECK HARNESS AND CONNECTOR (ECU - RECEIVER) |
![]() |
Disconnect the D33 ECU connector.
Disconnect the O11 receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D33-10 (RF5V) - O11-5 (+5V) | Always | Below 1 Ω |
| D33-9 (RDA) - O11-1 (RDA) | ||
| D33-4 (GND2) - O11-4 (GND) | ||
| D33-10 (RF5V) or O11-5 (+5V) - Body ground | 10 kΩ or higher | |
| D33-4 (GND2) or O11-4 (GND) - Body ground | ||
| D33-9 (RDA) or O11-1 (RDA) - Body ground |
|
| ||||
| OK | |
| 2.CHECK TIRE PRESSURE WARNING ECU |
![]() |
Reconnect the D33 ECU connector.
Turn the power switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D33-10 (RF5V) - D33-4 (GND2) | Power switch on (IG) | 4.5 to 5.5 V |
|
| ||||
| OK | ||
| ||