Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING RECEIVER (w/ Antenna)

TIRE PRESSURE WARNING RECEIVER (w/ Antenna) > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY


    C165674
  1. Connect the connector.



    C166575
  1. Install the tire pressure warning receiver assembly with the bolt.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



2. INSTALL ROOF HEADLINING ASSEMBLY

HINT:
Refer to the instructions for INSTALLATION of the roof headlining (Click here).



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. INSPECT TIRE PRESSURE WARNING SYSTEM

HINT:
Click here.