Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P060B    Internal Control Module A/D Processing Performance

for Preparation Click here


DESCRIPTION

This DTC is output when a communication error occurs in the ECM (included in the hybrid vehicle control ECU).

DTC No.
DTC Detection Condition
Trouble Area
P060B
Hybrid vehicle control ECU main CPU communication error
Hybrid vehicle control ECU

MONITOR STRATEGY


Related DTCs
None
Required sensors / components (main)
Hybrid vehicle control ECU
Required sensors / components (related)
-
Frequency of operation
Continuous
Duration
Within 1 second
MIL operation
Immediate
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever following DTCs are not present
None

TYPICAL MALFUNCTION THRESHOLDS


When one of following conditions is met:
-
Internal control module serial communication
Fail
AD converter
Fail

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Disconnect the cable from the negative battery terminal and wait for 1 minute.

  1. Connect the cable to the negative battery terminal.

  1. Turn the power switch on (IG).

  1. Check for DTCs.

    Result:

    Display (DTC Output)
    Proceed to
    No output
    A
    P060B
    B
    P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C, P033D
    C



B
REPLACE HYBRID VEHICLE CONTROL ECU (Click here)

C
GO TO DTC (P0327, P0328, P0332, P0333 and P033D) (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)