HYBRID BATTERY SYSTEM > DTC CHECK / CLEAR |
| CHECK FOR DTCs |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check the DTCs and freeze frame data, and then write them down.
Check the details of the DTCs (Click here).
| CHECK FREEZE FRAME DATA AND INFORMATION |
If a DTC is present, select it in order to display its freeze frame data.
Read the freeze frame data recorded when the DTC was set.
Read the information.
Select the item from among INFORMATION 1 to 5 that has an INF code on the freeze frame data screen.
| CHECK FOR DTCs (SYSTEMS OTHER THAN THE HYBRID VEHICLE CONTROL ECU) |
If DTCs are present, check the relevant systems.
HINT:
If DTCs for the CAN communication system are present in addition to other DTCs, first troubleshoot and repair any malfunctions in the CAN communication system.
| CLEAR DTCs |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Check that the P shift position has been selected.
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Clear DTCs and freeze frame data.