When DTCs for the following systems are stored, this DTC is stored simultaneously.
Lane departure alert system
CAN communication system
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B124B | Automatic High Beam System | Malfunction in automatic high beam system
(Detected for 2 seconds or more) |
·
Lane departure alert system ·
CAN communication system ·
Lane departure warning camera ·
Main body ECU (multiplex network body ECU) |
Confirm that there are no CAN communication system malfunctions before performing the following inspection.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.*
*: w/ Smart Entry and Start System
As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), first perform the inspections in On-Vehicle Inspection to confirm that there are no malfunctions in the power source circuit for the main body ECU (multiplex network body ECU) before performing this troubleshooting procedure.*
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION
*: for LHD
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR
DTC B124B is not output.
| Result | Proceed to |
|---|---|
| DTC B124B is not output | A |
| DTC B124B is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| Lane departure alert system DTCs are not output | A |
| Lane departure alert system DTCs are output | B |
| CAN communication system DTCs are output | C |
A
B
C
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Replace the lane departure warning camera with a new or known good one.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>REMOVAL
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR
DTC B124B is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG