Home › Engine / Hybrid System › 2GR-FE STARTING › STARTER › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019669 2GR-FE STARTING _0105672 STARTER A

2GR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53295E 3.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 11209 4.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 17750A 5.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 17705 6.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 17801 7.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17701 8.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 28100 10.REMOVE STARTER ASSEMBLY

a.
A170648

Open the terminal cap.


b.

Remove the nut and disconnect terminal 30.


c.

Disconnect the starter assembly connector.


d.
A170649

Remove the 2 bolts and starter assembly.