According to the sliding roof switch (map light assembly) operation, the sliding roof ECU (sliding roof drive gear sub-assembly) operates its built-in motor. Using the sliding roof switch (map light assembly), if the roof glass can be operated normally when 43 seconds or more have elapsed after the engine switch was turned off, the key-off operation function may be abnormal.
If the sliding roof ECU (sliding roof drive gear sub-assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear sub-assembly) must be initialized.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>INITIALIZATION
The sliding roof system uses the CAN and LIN communication systems. First, confirm that there are no malfunctions in the CAN and LIN communication systems. Refer to How to Proceed with Troubleshooting.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.
As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), first perform the inspections in On-Vehicle Inspection to confirm that there are no malfunctions in the power source circuit for the main body ECU (multiplex network body ECU) before performing this troubleshooting procedure.*
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION
*: for LHD
Check if the key-off operation function of the power window control system operates normally.
The key-off operation function of the power window control system operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG