Front passenger door:
When the ignition switch is ON, the power window regulator master switch assembly sends remote up and down signals to the power window regulator motor assembly (for front passenger door) via LIN communication.
Rear doors:
When the ignition switch is ON, the power window regulator master switch assembly sends remote up and down signals to the rear power window regulator switch assembly (for LH door or RH door). Then, the rear power window regulator switch assembly (for LH door or RH door) drives each power window regulator motor assembly.
The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
If the power window regulator motor assembly (for front passenger door) has been replaced with a new one, initialize the power window control system.
Inspect the fuses for circuits related to this system before performing the following procedure.
As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), first perform the inspections in On-Vehicle Inspection to confirm that there are no malfunctions in the power source circuit for the main body ECU (multiplex network body ECU) before performing this troubleshooting procedure.*
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION
*: for LHD
Turn the window lock switch off and operate the switches on the power window regulator master switch assembly. Check that the remote up and down function operates normally.
Remote up and down function operates normally.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (Front passenger door power window remote up and down function does not operate) | B |
| NG (Rear LH door power window remote up and down function does not operate) | C |
| NG (Rear RH door power window remote up and down function does not operate) |
A
B
C
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Communication P-Door Motor | Connection status between power window regulator motor assembly (for front passenger door) and main body ECU (multiplex network body ECU) | STOP or OK | STOP: Communication stopped
OK: Normal communication |
- |
| Communication Master SW | Connection status between power window regulator master switch assembly and main body ECU (multiplex network body ECU) | STOP or OK | STOP: Communication stopped
OK: Normal communication |
- |
| Tester Display |
|---|
| Communication P-Door Motor |
| Communication Master SW |
On the GTS screen, OK is displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Enter the following menus: Body Electrical / Master Switch / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| P Door P/W Auto SW | Front passenger door power window auto up and down switch signal | OFF or ON | OFF: Front passenger door power window auto switch not being operated
ON: Front passenger door power window auto switch being operated |
- |
| P Door P/W Up SW | Front passenger door power window manual up switch signal | OFF or ON | OFF: Front passenger door power window manual up switch not being operated
ON: Front passenger door power window manual up switch being operated |
- |
| P Door P/W Down SW | Front passenger door power window manual down switch signal | OFF or ON | OFF: Front passenger door power window manual down switch not being operated
ON: Front passenger door power window manual down switch being operated |
- |
| Window Lock Switch Status | Window lock switch signal | OFF or ON | OFF: Window lock switch UNLOCK position
ON: Window lock switch LOCK position |
- |
| Tester Display |
|---|
| P Door P/W Auto SW |
| P Door P/W Up SW |
| P Door P/W Down SW |
| Window Lock Switch Status |
On the GTS screen, ON or OFF is displayed accordingly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the operation of the rear LH and rear RH door power windows by using the rear power window regulator switch assembly (for LH door or RH door).
| Result | Proceed to |
|---|---|
·
Rear LH and rear RH door power windows operate normally by using the rear power window regulator switch assembly (for LH door or RH door) ·
Rear LH and rear RH door power windows do not operate by using the rear power window regulator switch assembly (for LH door or RH door) |
A |
| Only rear LH door power window does not operate using the rear power window regulator switch assembly (for LH door) | B |
| Only rear RH door power window does not operate using the rear power window regulator switch assembly (for RH door) | C |
A
B
C