Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Front Door Windows)
RM3160E _59 Vehicle Exterior _019717 WINDOW / GLASS _0106114 POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Front Door Windows) J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Front Door Windows)  Rear Power Window RH does not Operate with Rear Power Window Switch RH  


DESCRIPTION

When the ignition switch is ON, the power window regulator motor assembly (for rear RH door) is operated by the rear power window regulator switch assembly (for RH door).

WIRING DIAGRAM

B363309
0.469,0.656 1.792,0.865 1.323,0.208 10 false from PWR Relay 0.729,0.198 1.667,0.417 0.938,0.219 10 false from Battery 1.823,0.802 2.479,1.021 0.656,0.219 10 false P/W R/R 2,0.333 2.417,0.542 0.417,0.208 10 false A/C 1.531,1.813 1.688,2.01 0.156,0.198 10 false 2 3.271,1.906 3.542,2.125 0.271,0.219 10 false SU 2.594,1.458 2.75,1.656 0.156,0.198 10 false 2 1.542,2.167 1.698,2.365 0.156,0.198 10 false 1 2.583,1.813 2.74,2.01 0.156,0.198 10 false 7 6.396,2.083 6.552,2.281 0.156,0.198 10 false 1 2.583,2.167 2.74,2.365 0.156,0.198 10 false 1 1.365,2.271 1.521,2.469 0.156,0.198 10 false D 1.365,1.906 1.521,2.104 0.156,0.198 10 false U 2.771,2.26 2.927,2.458 0.156,0.198 10 false D 2.771,1.917 2.927,2.115 0.156,0.198 10 false U 2.771,1.552 2.927,1.75 0.156,0.198 10 false B 3.281,2.26 3.552,2.479 0.271,0.219 10 false SD 3.552,1.823 3.74,2.01 0.188,0.188 10 false 3 3.552,2.177 3.74,2.365 0.188,0.188 10 false 4 4.229,1.469 4.417,1.656 0.188,0.188 10 false 3 4.167,1.823 4.385,2.01 0.219,0.188 10 false 10 4.167,2.177 4.385,2.365 0.219,0.188 10 false 16 4.417,1.573 4.573,1.771 0.156,0.198 10 false B 4.406,1.917 4.865,2.115 0.458,0.198 10 false RRU 4.406,2.26 4.865,2.458 0.458,0.198 10 false RRD 5.99,2.208 6.385,2.385 0.396,0.177 10 false GND 4.531,2.781 4.844,2.979 0.313,0.198 10 false H6 0.219,2.469 0.531,2.667 0.313,0.198 10 false J1 2.188,2.448 2.5,2.646 0.313,0.198 10 false J5 0.219,2.625 1.813,3.177 1.594,0.552 10 false Power Window Regulator Motor Assembly (for Rear RH Door) 2.188,2.625 4.104,3.083 1.917,0.458 10 false Rear Power Window Regulator Switch Assembly (for RH Door) 4.531,2.938 6.104,3.375 1.573,0.438 10 false Power Window Regulator Master Switch Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

Check that the window lock switch is off before performing the following procedure.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR RH DOOR) - BATTERY)
a.

Disconnect the J5 rear power window regulator switch assembly (for RH door) connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
J5-2 (B) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR RH DOOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR RH DOOR)
a.

Remove the rear power window regulator switch assembly (for RH door).

Click hereVehicle Exterior>WINDOW / GLASS>REAR POWER WINDOW SWITCH>REMOVAL


b.

Inspect the rear power window regulator switch assembly (for RH door).

Click hereVehicle Exterior>WINDOW / GLASS>REAR POWER WINDOW SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR RH DOOR) - POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR RH DOOR))

NG

REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR RH DOOR)

3.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR RH DOOR) - POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR RH DOOR))
a.

Disconnect the J1 power window regulator motor assembly (for rear RH door) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
J5-7 (U) - J1-2 (U) Always Below 1 Ω
J5-7 (U) or J1-2 (U) - Body ground Always 10 kΩ or higher
J5-1 (D) - J1-1 (D) Always Below 1 Ω
J5-1 (D) or J1-1 (D) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
a.

Remove the power window regulator master switch assembly.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW MASTER SWITCH>REMOVAL


b.

Inspect the power window regulator master switch assembly.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW MASTER SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY - REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR RH DOOR)

NG

REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY - REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR RH DOOR)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H6-10 (RRU) - J5-3 (SU) Always Below 1 Ω
H6-10 (RRU) or J5-3 (SU) - Body ground Always 10 kΩ or higher
H6-16 (RRD) - J5-4 (SD) Always Below 1 Ω
H6-16 (RRD) or J5-4 (SD) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR RH DOOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR