Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH › 2013.12–2016.11
RM3160E _52 Drivetrain _019725 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0107322 PARK / NEUTRAL POSITION SWITCH A

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 53299D 1.REMOVE RADIATOR SIDE DEFLECTOR SEAL LH

Hide 53298E 2.REMOVE RADIATOR SIDE SEAL RH

Hide 53295E 3.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17750A 4.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 17705 5.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 17801 6.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17701 7.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 33820B 8.SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C239656

Disengage the wire harness clamp from the wire harness clamp bracket.


c.
C201710

Remove the nut from the transmission control shaft lever.


d.
C296586

Using a screwdriver, disengage the 4 claws, separate the transmission control cable assembly with clip from the No. 1 transmission control cable bracket.


e.
C227713

Using a screwdriver, disengage the 2 claws and remove the clip from the transmission control cable assembly.


Hide 84540 9.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Disconnect the connector from the park/neutral position switch.


b.
C136685

Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.


c.
C239670

Remove the 2 bolts and park/neutral position switch assembly from the manual valve lever shaft sub-assembly.

NOTICE:

Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the transmission control shaft lever. Be sure to remove the park/neutral position switch assembly straight along the transmission control shaft lever while being careful not to deform the plate spring that supports the transmission control shaft lever. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.