30500
1.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
36100
2.REMOVE TRANSFER ASSEMBLY
43410M
3.REMOVE FRONT DRIVE SHAFT OIL SEAL RH
for Outside:
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, pry out the front drive shaft oil seal RH from the automatic transaxle assembly.
Be careful not to damage the transaxle housing.
Tape the screwdriver tip before use.
for Inside:
Using SST, remove the front drive shaft oil seal RH from the differential case.
Be careful not to damage the differential case.
43410M
4.INSTALL FRONT DRIVE SHAFT OIL SEAL RH
for Inside:
Coat the lip of a new front drive shaft oil seal RH with MP grease.
Using SST and a hammer, install the front drive shaft oil seal RH to the differential case.
21.5 to 22.5 mm (0.847 to 0.885 in.)
Do not damage the front drive shaft oil seal RH lip.
for Outside:
Coat the lip of a new front drive shaft oil seal RH with MP grease.
Using SST and a hammer, install the front drive shaft oil seal RH to the automatic transaxle assembly.
5.5 to 6.5 mm (0.217 to 0.255 in.)
Make sure that the front drive shaft oil seal RH is installed in the correct direction.
Do not damage the front drive shaft oil seal RH lip.
36100
5.INSTALL TRANSFER ASSEMBLY
30500
6.INSTALL AUTOMATIC TRANSAXLE ASSEMBLY