33820B
1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and the shift lever are in neutral.
Pass the transmission control cable assembly from the cabin to the engine compartment.
Install the transmission control cable assembly with the 3 bolts.
Install the dash panel insulator to the original position.
Install a new clip to the No. 1 transmission control cable bracket.
| *a | Claw A |
| *b | Claw B |
| *c | Transmission Control Cable Assembly |
Connect the transmission control cable assembly to the No. 1 transmission control cable bracket.
Make sure that the claws A on the clip are securely fit into the No. 1 transmission control cable bracket holes.
Make sure that the transmission control cable assembly is securely installed inside of the claws B of the clip.
Connect the transmission control cable assembly to the transmission control shaft lever with the nut.
Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and the shift lever are in neutral.
Engage the wire harness clamp.
| *a | Slider |
| *b | Lock Piece |
| *c | Slide |
| *d | Pull |
Slide the slider of the transmission control cable assembly in the direction indicated by the arrow in the illustration and pull the lock piece outward.
| *a | Lock Nut |
| *b | Push in |
| *c | Stopper |
Turn the lock nut of the transmission control cable assembly counterclockwise. While holding the lock nut, push in the stopper.
| *a | Stopper |
Install the outer part of the transmission control cable assembly to the transmission floor shift assembly.
After installation, check that the outer part of the cable lock is protruding beyond portion A-A as shown in the illustration.
| *a | Lock Piece |
| *b | Adjuster Case |
Install the end of the transmission control cable assembly to the transmission floor shift assembly.
Check that the lock piece is pulled out.
Install the cable end all the way to the base of the transmission floor shift assembly pin.
Push the lock piece into the adjuster case.
Check that the park/neutral position switch assembly and shift lever are in neutral.
Securely push in the lock piece until the slider lock is engaged.
2.INSTALL AIR CONDITIONING UNIT ASSEMBLY
17701
3.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17801
4.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
17705
5.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
17750A
6.INSTALL INLET AIR CLEANER ASSEMBLY
53295E
7.INSTALL COOL AIR INTAKE DUCT SEAL
53298E
8.INSTALL RADIATOR SIDE SEAL RH
53299D
9.INSTALL RADIATOR SIDE DEFLECTOR SEAL LH
10.INSPECT SHIFT LEVER POSITION
11.ADJUST SHIFT LEVER POSITION