1.DRAIN TRANSFER OIL
43410
2.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
36113A
3.REMOVE TRANSFER CASE OIL SEAL RH
Using SST, remove the transfer case oil seal RH from the transfer assembly.
Do not damage the transfer case oil seal RH contact surface to the transfer assembly.
36113A
4.INSTALL TRANSFER CASE OIL SEAL RH
| *A | Type A |
| *B | Type B |
| *1 | Transfer Case Oil Seal RH |
| *a | Depth |
|
Install in this Direction |
Using SST and a hammer, install a new transfer case oil seal RH as shown in the illustration.
33.5 to 34.5 mm (1.32 to 1.35 in.)
Be sure to install the transfer case oil seal RH in the correct orientation.
Tap in the transfer case oil seal RH uniformly so that the transfer case oil seal RH is straight.
Do not tap in the transfer case oil seal RH in too far.
Apply a small amount of MP grease to the lip of the transfer case oil seal RH.
43410
5.INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
6.ADD TRANSFER OIL
7.INSPECT TRANSFER OIL LEAK