Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEELS
2.DRAIN AUTOMATIC TRANSAXLE FLUID
3.DRAIN TRANSFER OIL (for AWD)
43502H
4.REMOVE FRONT AXLE SHAFT NUT
Using SST and a hammer, release the staked part of the front axle shaft nut.
Loosen the staked part of the front axle shaft nut completely, otherwise the threads of the drive shaft may be damaged.
While applying the brakes, remove the front axle shaft nut.
89543
5.SEPARATE FRONT SPEED SENSOR
| *a | Sensor Clamp |
Disengage the 2 claws and separate the sensor clamp.
Remove the bolt and separate the front speed sensor and front flexible hose from the front shock absorber assembly.
Be sure to separate the front speed sensor from the front shock absorber assembly completely.
Remove the bolt and separate the front speed sensor from the steering knuckle.
Prevent foreign matter from contacting the sensor tip.
Be careful not to damage the front speed sensor.
Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.
45470
6.SEPARATE TIE ROD ASSEMBLY
for 2WD: Click hereSteering>STEERING GEAR / LINKAGE>STEERING GEAR(for 2WD)>REMOVAL
for AWD: Click hereSteering>STEERING GEAR / LINKAGE>STEERING GEAR(for AWD)>REMOVAL
48810
7.SEPARATE FRONT STABILIZER LINK ASSEMBLY
48069
8.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
9.SEPARATE FRONT DRIVE SHAFT ASSEMBLY
43420
10.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
Using SST, remove the front drive shaft assembly LH.
Do not damage the front drive shaft oil seal LH.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly LH.
43410
11.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
for 2WD:
Separate the bearing bracket hole snap ring from the drive shaft bearing bracket.
Remove the No. 1 drive shaft bearing bracket setting bolt and front drive shaft assembly RH from the drive shaft bearing bracket.
Do not damage the front drive shaft oil seal RH.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly RH.
for AWD:
Separate the bearing bracket hole snap ring from the transfer assembly.
Remove the No. 1 drive shaft bearing bracket setting bolt and front drive shaft assembly RH from the transfer assembly.
Do not damage the transfer case oil seal RH.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly RH.
Remove the bearing bracket hole snap ring from the front drive shaft assembly RH.
43420G
12.REMOVE FRONT DRIVE SHAFT HOLE SNAP RING (for LH Side)
Using a screwdriver, remove the front drive shaft hole snap ring.