Home › Drivetrain › MF1A (TRANSFER / 4WD / AWD) › TRANSFER CASE REAR OIL SEAL › 2013.12–2015.11
RM3160E _52 Drivetrain _019685 MF1A TRANSFER / 4WD / AWD _0107525 TRANSFER CASE REAR OIL SEAL A

MF1A TRANSFER / 4WD / AWD  TRANSFER CASE REAR OIL SEAL  REPLACEMENT  


PROCEDURE

Hide 37100 1.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

Hide 36115C 2.REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

a.
C155230E01
2.221,0.114 2.568,0.324 0.347,0.21 10 SST 2.179,0.192 2.023,0.192 2.023,0.192 1.925,0.515 false

Using SST, remove the transfer extension housing type T oil seal from the transfer assembly.

SST
09308-00010  

NOTICE:

Be careful not to damage the transfer extension housing type T oil seal contact surface or the inside surface of the transfer extension housing type T oil seal.



Hide 36115C 3.INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

a.
C155219E01
2.441,1.436 2.768,1.621 0.327,0.185 10 SST 2.604,1.219 2.604,1.421 false

Using SST and a hammer, install a new transfer extension housing type T oil seal to the transfer assembly until it reaches the position shown in the illustration.

SST
09325-20010  

Standard Depth:

1.1 to 1.9 mm (0.0434 to 0.0748 in.)


NOTICE:

Do not tilt the transfer extension housing type T oil seal during installation.



b.

Apply a small amount of MP grease to the lip of the transfer extension housing type T oil seal.


Hide 37100 4.INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY