Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE REAR WHEEL
2.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
42491
3.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
42431
4.REMOVE REAR DISC
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
46550G
5.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Upper Side)
Remove the 2 parking brake shoe return tension springs.
Be sure to put an identification mark on each parking brake shoe return tension spring so that it can be reinstalled to its original position.
46580
6.SEPARATE NO. 1 PARKING BRAKE SHOE ASSEMBLY
Remove the parking brake shoe hold down spring cup and parking brake shoe hold down compression spring to separate the No. 1 parking brake shoe assembly from the backing plate.
46612
7.REMOVE PARKING BRAKE SHOE LEVER STRUT
Pull the No. 1 parking brake shoe assembly towards the front of the vehicle by hand as shown in the illustration.
Remove the parking brake shoe lever strut.
47613D
8.REMOVE PARKING BRAKE SHOE STRUT COMPRESSION SPRING
Remove the parking brake shoe strut compression spring.
46590
9.SEPARATE NO. 2 PARKING BRAKE SHOE ASSEMBLY
Remove the parking brake shoe hold down spring cup and parking brake shoe hold down compression spring to separate the No. 2 parking brake shoe assembly from the backing plate.
47406A
10.REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET
Remove the parking brake shoe adjusting screw set.
46580
11.REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY
Remove the No. 1 parking brake shoe assembly.
46550E
12.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Lower Side)
Remove the parking brake shoe return tension spring.
47612
13.SEPARATE PARKING BRAKE SHOE LEVER
Using needle-nose pliers, separate the parking brake shoe lever from the No. 3 parking brake cable assembly.
Be careful not to damage the No. 3 parking brake cable assembly.
47612
14.REMOVE PARKING BRAKE SHOE LEVER
Using a screwdriver, remove the parking brake shoe type C washer, parking brake shoe shim and parking brake shoe lever.
Parking brake shoe shims are provided when necessary to adjust the clearance between the parking brake shoe lever and parking brake shoe type C washer. Some vehicles may not be equipped with shims.
47447C
15.REMOVE PARKING BRAKE SHOE HOLD DOWN SPRING PIN
for Front Side:
Remove the parking brake shoe hold down spring pin.
for Rear Side:
Remove the parking brake shoe hold down spring pin.
47456A
16.REMOVE PARKING BRAKE SHOE GUIDE PLATE
Remove the parking brake shoe guide plate set bolt and parking brake shoe guide plate.