44785
1.INSTALL BRAKE BOOSTER GASKET
Install a new brake booster gasket to the brake booster assembly.
44610
2.INSTALL BRAKE BOOSTER ASSEMBLY
Temporarily install the brake booster assembly to the vehicle body.
Do not apply excessive force to the brake lines or refrigerant lines.
Temporarily install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.
Fully tighten the lock nut when adjusting the brake pedal height.
Install the 4 nuts to secure the brake booster assembly.
47264A
3.INSTALL PUSH ROD PIN
47101A
4.INSTALL BRAKE PEDAL RETURN SPRING
5.INSTALL BRAKE LINE
Install the 3 brake lines to the brake tube clamp.
Do not kink or damage the brake lines.
Do not damage the clamp.
Install the bolt to secure front No. 1 brake tube way.
Do not kink or damage the brake lines.
6.INSTALL AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY
Install the air conditioner tube and accessory assembly with the nut.
Do not deform the refrigerant lines.
Do not damage the clamp.
88704
7.INSTALL SUCTION HOSE SUB-ASSEMBLY
Install the suction hose sub-assembly to the piping clamp.
Do not deform the refrigerant lines.
Do not damage the clamp.
Engage the claw to secure the suction hose sub-assembly.
44777
8.CONNECT NO. 1 VACUUM HOSE CONNECTOR (for 1AR-FE)
Install the No. 1 vacuum hose connector with the 2 nuts.
Connect the union to check valve hose to the brake booster assembly, and slide the clip to secure it.
44773F
9.CONNECT UNION TO CHECK VALVE HOSE (for 2GR-FE)
Connect the union to check valve hose to the brake booster assembly, and slide the clip to secure it.
23820
10.CONNECT FUEL VAPOR FEED HOSE ASSEMBLY
Connect the fuel vapor feed hose assembly, and slide the clip to secure it.
82121
11.INSTALL ENGINE WIRE
Engage the 3 clamps to install the engine wire.
82111
12.INSTALL ENGINE ROOM MAIN WIRE
Engage the 2 pins to install the engine room relay block assembly.
Install the 2 bolts.
| *a | Clamp |
| *b | Pin |
Engage the 2 clamps and pin to install the wire harness protector.
Install the bolt to secure the wire harness protector.
w/ Security Horn Assembly:
Connect the connector to the security horn assembly.
Engage the 5 clamps to install the engine room main wire.
89661
13.INSTALL ECM
for 1AR-FE: Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>ECM>INSTALLATION
for 2GR-FE: Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>ECM>INSTALLATION
47233
14.INSTALL RESERVOIR BRACKET
Install the reservoir bracket with the 2 bolts.
47220D
15.INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY
| *1 | Brake Master Cylinder Reservoir Assembly |
| *2 | Reservoir Bracket |
Move the brake master cylinder reservoir assembly as shown in the illustration to engage the 2 claws.
Connect the reservoir level switch connector and install the bolt.
55701J
16.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
17.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
18.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY WITH WAY
19.INSPECT AND ADJUST BRAKE PEDAL