88172
1.INSTALL BLIND SPOT MONITOR SENSOR LH
Install the blind spot monitor sensor LH with the 3 nuts.
Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.
Connect the connector.
88162
2.INSTALL BLIND SPOT MONITOR SENSOR RH
Install the blind spot monitor sensor RH with the 3 nuts.
Replace the blind spot monitor sensor RH if it has been dropped or subjected to a severe impact.
Connect the connector.
3.INSTALL REAR BUMPER ASSEMBLY
4.PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION
5.PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK
6.PERFORM DIAGNOSTIC SYSTEM CHECK