Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING
RM3160E _59 Vehicle Exterior _019724 EXTERIOR PANELS / TRIM _0109641 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 69284D 3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Hide 67488C 5.REMOVE REAR DOOR REAR GUIDE SEAL

Hide 67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67842E 7.REMOVE REAR DOOR SERVICE HOLE COVER

Hide 67858B 8.REMOVE REAR DOOR PANEL PROTECTOR

Hide 68152C 10.REMOVE REAR DOOR GLASS RUN

Hide 67408E 11.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Hide 68104 12.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Hide 75740 13.REMOVE REAR DOOR BELT MOULDING ASSEMBLY

a.
B363121C01
0.625,1.208 0.74,1.198 false
V100155

Protective Tape


Apply protective tape around the rear door belt moulding assembly.


b.
B363122C01
1.792,3.167 2.156,3.115 false 2.188,3.042 2.5,3.198 0.313,0.156 10 false *a 0.583,0.5 0.74,0.698 0.156,0.198 10 false A 2.313,0.458 2.469,0.656 0.156,0.198 10 false A 1.604,2.448 1.76,2.646 0.156,0.198 10 false B
*a Protective Tape


Disengage the 2 claws (A).


c.

Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws (B) and remove the rear door belt moulding assembly.