Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
69284D
3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
67488C
5.REMOVE REAR DOOR REAR GUIDE SEAL
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
67842E
7.REMOVE REAR DOOR SERVICE HOLE COVER
67858B
8.REMOVE REAR DOOR PANEL PROTECTOR
67872
9.DISCONNECT REAR DOOR WEATHERSTRIP
68152C
10.REMOVE REAR DOOR GLASS RUN
67408E
11.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
68104
12.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
67673A
13.REMOVE REAR DOOR FRAME GARNISH (w/o Rear Door Sunshade)
67674A
14.REMOVE REAR DOOR FRAME GARNISH (w/ Rear Door Sunshade)
75952A
15.REMOVE FRONT INNER BLACK OUT TAPE
Using a heat light, heat the front inner black out tape and vehicle body.
| Item | Temperature |
|---|---|
| Front Inner Black Out Tape and Vehicle Body | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body excessively.
Pull back on one of the ends of the front inner black out tape to remove it.
When pulling on the front inner black out tape, pull it parallel to the body.
75954A
16.REMOVE REAR INNER BLACK OUT TAPE
Using a heat light, heat the rear inner black out tape and vehicle body.
| Item | Temperature |
|---|---|
| Rear Inner Black Out Tape and Vehicle Body | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body excessively.
Pull back on one of the ends of the rear inner black out tape to remove it.
When pulling on the rear inner black out tape, pull it parallel to the body.
75938
17.REMOVE UPPER INNER BLACK OUT TAPE
Using a heat light, heat the upper inner black out tape and vehicle body.
| Item | Temperature |
|---|---|
| Upper Inner Black Out Tape and Vehicle Body | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body excessively.
Pull back on one of the ends of the upper inner black out tape to remove it.
When pulling on the upper inner black out tape, pull it parallel to the body.