Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL
RM3160E _52 Drivetrain _019687 AXLE AND DIFFERENTIAL _0109982 REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 42305 1.REMOVE REAR AXLE CARRIER SUB-ASSEMBLY

Hide 2.DRAIN DIFFERENTIAL OIL

a.
C201206

Using a 10 mm hexagon wrench, remove the differential inspection plug and gasket.


b.
C201207

Using a 10 mm hexagon wrench, remove the rear differential drain plug and gasket to drain the differential oil.


c.

Using a 10 mm hexagon wrench, install a new gasket and the rear differential drain plug.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


d.
C201206

Using a 10 mm hexagon wrench, temporarily install the differential inspection plug.

HINT:

Add differential oil before installing a new gasket and fully installing the differential inspection plug.



Hide 42340D 5.REMOVE REAR DRIVE SHAFT OIL SEAL

a.
C201211N02
1.375,2.51 1.552,2.333 1.552,2.333 1.771,2.333 false 1.271,0.74 1.604,0.74 true 1.802,2.25 2.156,2.448 0.354,0.198 10 false SST 0.979,0.667 1.333,0.865 0.354,0.198 10 false SST

Using SST, remove the rear drive shaft oil seal from the rear differential carrier assembly.

SST
09308-00010  


Hide 42340D 6.INSTALL REAR DRIVE SHAFT OIL SEAL

a.
C201212C01
2.323,2.438 1.823,2.438 1.823,2.438 1.823,2.667 false 2.208,2.771 2.208,2.438 false 2.281,1.188 2.917,1.188 false 2.396,1.427 2.646,1.427 2.646,1.427 2.646,1.188 false 2.375,2.354 2.74,2.552 0.365,0.198 10 false SST 2.948,1.104 3.281,1.313 0.333,0.208 10 false SST 1.375,2.427 1.583,2.594 0.208,0.167 10 false A

Using SST and a hammer, install a new rear drive shaft oil seal into the rear differential carrier assembly.

SST
09223-46011  09631-32020  

Standard Distance (A):

8.2 to 8.8 mm (0.323 to 0.346 in.)


NOTICE:
·

Install the rear drive shaft oil seal uniformly so that it is driven in straight.

·

Do not excessively tap in the rear drive shaft oil seal.




b.

Apply a light coat of MP grease to the lip of the new rear drive shaft oil seal.


Hide 9.ADD DIFFERENTIAL OIL

a.
C201206

Using a 10 mm hexagon wrench, remove the differential inspection plug.



Hide 41110X 11.INSTALL DIFFERENTIAL INSPECTION PLUG

Hide 12. INSPECT FOR DIFFERENTIAL OIL LEAK

Hide 42305 13.TEMPORARILY INSTALL REAR AXLE CARRIER SUB-ASSEMBLY