Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY
RM3160E _58 Vehicle Interior _019710 SUPPLEMENTAL RESTRAINT SYSTEMS _0109992 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 89170 1.INSTALL AIRBAG SENSOR ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B355827C01
0.323,1.073 0.542,1.073 0.542,1.073 0.854,0.74 true 0.135,0.969 0.302,1.188 0.167,0.219 10 true *a
*a Waterproof Sheet


Install the airbag sensor assembly with the 3 bolts.

Torque:
17.5 N*m (178 kgf*cm, 13 ft.*lbf)

NOTICE:
·

If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

·

When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

·

When the ignition switch is first turned to ON after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.




d.

Connect the connectors to the airbag sensor assembly as shown in the illustration.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



e.

Check that the waterproof sheet is properly set.


f.

Check that there is no looseness in the installed parts of the airbag sensor assembly.


Hide 58817A 3.INSTALL FRONT NO. 2 CONSOLE BOX INSERT

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 8. PERFORM INITIALIZATION

a.

When the airbag sensor assembly (center airbag sensor assembly) is replaced, perform initialization.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION