When the lane departure warning camera is replaced with a new one, it acquires the country specification information from the main body ECU (multiplex network body ECU). When the country specification information in the lane departure warning camera and main body ECU (multiplex network body ECU) do not match, DTC C1AA1 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AA1 | FCM Destination Information Unmatched | While the initial check is running with the engine switch on (IG) and the lane departure alert system is operating, country specification information in the lane departure warning camera and main body ECU (multiplex network body ECU) do not match for 3 seconds or more. | ·
Lane departure warning camera ·
Main body ECU (multiplex network body ECU) |
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.
When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera axis must be performed.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT
The lane departure alert system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the lane departure alert system after confirming that the communication systems are functioning properly.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Lane Departure Alert / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Destination Information | Status of the country | JPN, NA, EURO, CHINA or OTHER | Actual country code | - |
| Tester Display |
|---|
| Destination Information |
| Result | Proceed to |
|---|---|
| Country specification information for vehicle and lane departure warning camera match | A |
| Country specification information for vehicle and lane departure warning camera do not match | B |
A
B
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC C1AA1 is not output | A |
| DTC C1AA1 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B