Home › Drivetrain › MF1A (TRANSFER / 4WD / AWD) › TRANSFER CASE REAR OIL SEAL › from 2015.11
RM3160E _52 Drivetrain _019685 MF1A TRANSFER / 4WD / AWD _0107525 TRANSFER CASE REAR OIL SEAL A

MF1A TRANSFER / 4WD / AWD  TRANSFER CASE REAR OIL SEAL  REPLACEMENT  


PROCEDURE

Hide 37100 1.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

Hide 36115C 2.REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

a.
C326888C02
0.969,1.542 1.146,1.792 1.146,1.792 1.323,1.792 true 1.323,0.479 1.5,0.219 1.5,0.219 1.677,0.219 false 1.354,1.719 1.667,1.875 0.313,0.156 10 false *1 1.729,0.146 2.198,0.344 0.469,0.198 10 false SST
*1 Transfer Extension Housing Type T Oil Seal


Using SST, remove the transfer extension housing type T oil seal from the transfer extension housing sub-assembly.

SST
09308-00010  

NOTICE:

Be careful not to damage the transfer extension housing type T oil seal contact surface or the inside surface of the transfer extension housing type T oil seal.



Hide 36115C 3.INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

a.
C326889C01
1.833,1.844 1.646,1.844 1.646,1.844 1.573,1.427 true 2.667,1.677 2.479,1.677 2.479,1.677 2.406,1.26 true 1.875,1.76 2.188,1.917 0.313,0.156 10 false *1 1.677,0 1.99,0.156 0.313,0.156 10 false *a 2.719,1.583 3.031,1.74 0.313,0.156 10 false SST
*1 Transfer Extension Housing Type T Oil Seal
*a Depth


Using SST and a hammer, install a new transfer extension housing type T oil seal to the transfer extension housing sub-assembly until it reaches the position shown in the illustration.

SST
09325-20010  

Standard Depth:

9.8 to 10.6 mm (0.386 to 0.417 in.)


NOTICE:
·

Do not tilt the transfer extension housing type T oil seal during installation.

·

Do not tap in the transfer extension housing type T oil seal in too far.




b.

Apply a small amount of MP grease to the lip of the transfer extension housing type T oil seal.


Hide 37100 4.INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY