When removing the cooler expansion valve by itself, be sure to install a new cooler expansion valve and new bolt for the suction hose sub-assembly.
1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for 2GR-FKS)
55701J
3.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for 2GR-FKS)
for LHD:
Click hereSuspension>FRONT SUSPENSION>FRONT SHOCK ABSORBER>REMOVAL
for RHD:
Click hereSuspension>FRONT SUSPENSION>FRONT SHOCK ABSORBER>REMOVAL
88704
4.DISCONNECT SUCTION HOSE SUB-ASSEMBLY
5.DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY
88515
6.REMOVE COOLER EXPANSION VALVE
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts.
| *a | Bolt for Suction Hose Sub-assembly |
Temporarily install the bolt for the suction hose sub-assembly halfway to the cooler expansion valve.
Hold the bolt and pull it to remove the cooler expansion valve as shown in the illustration.
| *1 | No. 1 Cooler Evaporator Sub-assembly |
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.