Home › Vehicle Interior › HEATING / AIR CONDITIONING › COOLER EXPANSION VALVE(for Front) › from 2016.11
RM3160E _58 Vehicle Interior _019714 HEATING / AIR CONDITIONING _0109962 COOLER EXPANSION VALVE(for Front) A

HEATING / AIR CONDITIONING  COOLER EXPANSION VALVE(for Front)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

When removing the cooler expansion valve by itself, be sure to install a new cooler expansion valve and new bolt for the suction hose sub-assembly.


PROCEDURE

Hide 88515 1.INSTALL COOLER EXPANSION VALVE

a.

Apply sufficient compressor oil to 2 new O-rings and the fitting surfaces of a new cooler expansion valve.

Compressor Oil:

ND-OIL 8 or equivalent



b.

Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.

NOTICE:

Keep the O-rings and O-ring fitting surfaces free from dirt and foreign matter.



c.

Using a 4 mm hexagon wrench, install a new cooler expansion valve with the 2 hexagon bolts.

Torque:
3.5 N*m (36 kgf*cm, 31 in.*lbf)


Hide 2.CONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY

Hide 88704 3.CONNECT SUCTION HOSE SUB-ASSEMBLY

a.

Remove the vinyl tape from the suction hose sub-assembly.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the suction hose sub-assembly.

Compressor Oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the suction hose sub-assembly.

NOTICE:

Keep the O-ring and O-ring fitting surface free from dirt and foreign matter.



d.

Connect the suction hose sub-assembly.


e.
E285664

Rotate the hook connector as shown in the illustration.


f.

Insert the hose joint into the fitting hole securely and install a new bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 55701J 4.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for 2GR-FKS)

Hide 5.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for 2GR-FKS)

Hide 6.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT