Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 6 Sensor Type) › from 2016.11
RM3160E _56 Audio / Visual / Telematics _019702 PARK ASSIST / MONITORING _0297894 TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 6 Sensor Type) C

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 6 Sensor Type)  C1AE1  Front Left Sensor Malfunction  


DESCRIPTION

The No. 1 ultrasonic sensor (front left sensor) is installed on the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the No. 1 ultrasonic sensor (front left sensor). If the No. 1 ultrasonic sensor (front left sensor) has an open circuit or other malfunction, it will not function normally.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AE1 Front Left Sensor Malfunction A malfunction of the No. 1 ultrasonic sensor (front left sensor)
·

No. 1 ultrasonic sensor (front left sensor)

·

Harness or connector

·

Clearance warning ECU assembly



WIRING DIAGRAM

E308016E16
0.875,1.646 2.375,2.177 1.5,0.531 10 false No. 1 Ultrasonic Sensor (Front Left Sensor) 0.865,1.458 1.177,1.656 0.313,0.198 10 false t1 4.948,1.5 5.26,1.698 0.313,0.198 10 false F87 4.938,1.677 6.135,2.052 1.198,0.375 10 false Clearance Warning ECU Assembly 1.823,0.542 2.135,0.74 0.313,0.198 10 false S 1.823,1.177 2.135,1.375 0.313,0.198 10 false E 2.042,0.438 2.354,0.635 0.313,0.198 10 false 2 2.042,1.083 2.354,1.281 0.313,0.198 10 false 1 4.948,0.438 5.26,0.635 0.313,0.198 10 false 21 4.938,1.073 5.25,1.271 0.313,0.198 10 false 22 5.198,0.531 5.51,0.729 0.313,0.198 10 false S6 5.208,1.167 5.521,1.365 0.313,0.198 10 false E6

CAUTION / NOTICE / HINT

NOTICE:

If DTCs are output after repairs, turn the ignition switch to ON and turn the back sonar or clearance sonar switch assembly on. Then clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 6 Sensor Type)>DTC CHECK / CLEAR


PROCEDURE

1.INSPECT NO. 1 ULTRASONIC SENSOR (FRONT LEFT SENSOR)
a.

Remove the No. 1 ultrasonic sensor (front left sensor).

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Rear Side)>REMOVAL


b.
E257585C02
1.042,0.698 1.396,1.052 false 2.375,0.698 2.021,1.052 false 0.156,0.125 0.438,0.313 0.281,0.188 10 false *a 0.958,0.51 1.24,0.698 0.281,0.188 10 false S 2.365,0.51 2.646,0.698 0.281,0.188 10 false E
*a Component without harness connected
(No. 1 Ultrasonic Sensor (Front Left Sensor))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (S) - 1 (E) Always 20 to 40 kΩ


Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (NO. 1 ULTRASONIC SENSOR (FRONT LEFT SENSOR) - CLEARANCE WARNING ECU ASSEMBLY)

NG

REPLACE NO. 1 ULTRASONIC SENSOR (FRONT LEFT SENSOR)

2.CHECK HARNESS AND CONNECTOR (NO. 1 ULTRASONIC SENSOR (FRONT LEFT SENSOR) - CLEARANCE WARNING ECU ASSEMBLY)
a.

Disconnect the F87 clearance warning ECU assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
t1-2 (S) - F87-21 (S6) Always Below 1 Ω
t1-1 (E) - F87-22 (E6) Always Below 1 Ω
t1-2 (S) or F87-21 (S6) - Body ground Always 10 kΩ or higher
t1-1 (E) or F87-22 (E6) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR