After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67913
2.REMOVE FRONT DOOR SCUFF PLATE
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62111A
3.REMOVE COWL SIDE TRIM SUB-ASSEMBLY
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
4.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
55435A
5.REMOVE INSTRUMENT PANEL FINISH PANEL END
55607
6.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
7.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
82877
8.REMOVE ECU INTEGRATION BOX RH (for LHD)
82878
9.REMOVE ECU INTEGRATION BOX LH (for RHD)
89340A
10.REMOVE CLEARANCE WARNING ECU ASSEMBLY
for LHD:
Disengage the 2 claws to remove the clearance warning ECU assembly.
for RHD:
Disengage the 2 claws to remove the clearance warning ECU assembly.