The No. 1 ultrasonic sensor (rear right sensor) is installed on the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the No. 1 ultrasonic sensor (rear right sensor). If the No. 1 ultrasonic sensor (rear right sensor) has an open circuit or other malfunction, it will not function normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE9 | Rear Right Sensor Malfunction | A malfunction of the No. 1 ultrasonic sensor (rear right sensor) | ·
No. 1 ultrasonic sensor (rear right sensor) ·
Harness or connector ·
Clearance warning ECU assembly |
If DTCs are output after repairs, turn the ignition switch to ON and turn the back sonar or clearance sonar switch assembly on. Then clear the DTCs.
Remove the No. 1 ultrasonic sensor (rear right sensor).
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Rear Side)>REMOVAL
| *a | Component without harness connected
(No. 1 Ultrasonic Sensor (Rear Right Sensor)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (S) - 1 (E) | Always | 20 to 40 kΩ |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Rear Side)>REMOVAL
Disconnect the F87 clearance warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| W1-2 (S) - F87-1 (S1) | Always | Below 1 Ω |
| W1-1 (E) - F87-2 (E1) | Always | Below 1 Ω |
| W1-2 (S) or F87-1 (S1) - Body ground | Always | 10 kΩ or higher |
| W1-1 (E) or F87-2 (E1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG