36100
1.REMOVE TRANSFER ASSEMBLY
36111B
2.REMOVE TRANSFER CASE OIL SEAL
Using SST, remove the transfer case oil seal from the transfer assembly.
Do not damage the transfer case oil seal contact surface to the transfer assembly.
Wear or damage to the front drive shaft oil seal RH on the transmission side will cause transfer oil leakage.
If it is worn or damaged, replace the front drive shaft oil seal RH.
Click hereDrivetrain>UA80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>DIFFERENTIAL OIL SEAL(for RH Side)>REPLACEMENT
36111B
3.INSTALL TRANSFER CASE OIL SEAL
Using SST and a hammer, install a new transfer case oil seal as shown in the illustration.
9.5 to 10.5 mm (0.375 to 0.413 in.)
Tap in the transfer case oil seal uniformly so that the transfer case oil seal is straight.
Do not tap in the transfer case oil seal in too far.
Apply a small amount of MP grease to the lip of the transfer case oil seal.
36100
4.INSTALL TRANSFER ASSEMBLY