Home › Engine / Hybrid System › 2GR-FKS (INTAKE / EXHAUST) › INTAKE SYSTEM › from 2016.11
RM3160E _51 Engine / Hybrid System _060160 2GR-FKS INTAKE / EXHAUST _0299811 INTAKE SYSTEM G

2GR-FKS INTAKE / EXHAUST  INTAKE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT INTAKE SYSTEM

a.

Check that there are no vacuum leaks at the points shown in the illustration.

HINT:

Perform Inspection After Repair after repairing vacuum leaks in the intake system.

Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


i.

for LHD:

A395736


ii.

for RHD:

A395777



Hide 2.INSPECT INTAKE AIR CONTROL VALVE (for ACIS)

a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.
A395741C01
0.885,2.948 0.885,2.573 true 0.833,2.938 1.052,3.156 0.219,0.219 10 true *a
*a Actuator Rod


Enter the following menus: Powertrain / Engine / Active Test / Activate the EVAP Purge VSV.

Powertrain > Engine > Active Test
Tester Display
Activate the EVAP Purge VSV
50004 372 1

e.

When Activate the VSV for Intake Control is set to on, check that the actuator rod operates.

If the actuator rod does not operate, inspect the intake air control valve (for ACIS) and No. 1 vacuum switching valve assembly (for ACIS).



f.

When Activate the VSV for Intake Control is set to off, check that the actuator rod returns to its original position.

If the actuator rod does not return to its original position, inspect the intake air control valve (for ACIS) and No. 1 vacuum switching valve assembly (for ACIS).



Hide 3.PERFORM INITIALIZATION

a.

Perform Inspection After Repair after repairing vacuum leaks in the intake system.

Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION