Home › Engine / Hybrid System › 2GR-FKS (INTAKE / EXHAUST) › EXHAUST PIPE › from 2016.11
RM3160E _51 Engine / Hybrid System _060160 2GR-FKS INTAKE / EXHAUST _0299816 EXHAUST PIPE A

2GR-FKS INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51442 2.REMOVE NO. 2 ENGINE UNDER COVER

Hide 17430 4.REMOVE TAIL EXHAUST PIPE ASSEMBLY

a.
A314579

Remove the 2 bolts and disconnect the tail exhaust pipe assembly from the center exhaust pipe assembly (TWC: Rear Catalyst).


b.
A314578

Remove the tail exhaust pipe assembly from the 4 exhaust pipe supports.


c.

Remove the gasket from the center exhaust pipe assembly (TWC: Rear Catalyst).


Hide 17581C 5.REMOVE NO. 3 EXHAUST PIPE DAMPER

a.
A395766

Remove the 2 bolts and No. 3 exhaust pipe damper from the tail exhaust pipe assembly.


Hide 17420 6.REMOVE CENTER EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

a.
A395767

Remove the 2 bolts and 2 compression springs to disconnect the center exhaust pipe assembly (TWC: Rear Catalyst) from the front No. 3 exhaust pipe sub-assembly.


b.

Remove the center exhaust pipe assembly (TWC: Rear Catalyst) from the exhaust pipe support.


c.

Remove the gasket from the front No. 3 exhaust pipe sub-assembly.


Hide 17403 7.REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY

a.
A395768

Disengage the 3 wire harness clamps.


b.

Disconnect the heated oxygen sensor (for Bank 1) connector.


c.
A395769C01
0,0 0,0 false
V100135

Bolt
V100136

Nut


Remove the 2 bolts, 2 nuts and front No. 3 exhaust pipe sub-assembly from the front exhaust pipe assembly and exhaust manifold (TWC: Front Catalyst).


d.

Remove the 2 gaskets from the front No. 3 exhaust pipe sub-assembly.


Hide 89465 8.REMOVE HEATED OXYGEN SENSOR (for Bank 1)

a.
A369388

Remove the wire harness clamp bracket from the heated oxygen sensor (for Bank 1).


b.
A369389N01
0.542,0.802 0.771,0.802 0.771,0.802 0.823,1.042 true 0.219,0.719 0.542,0.917 0.323,0.198 10 false SST

Using SST, remove the heated oxygen sensor (for Bank 1) from the front No. 3 exhaust pipe sub-assembly.

SST
09224-00012  

NOTICE:

If the heated oxygen sensor has been struck or dropped, replace it.



Hide 17584B 9.REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side)

a.
A395770

Remove the 2 bolts and No. 1 exhaust pipe support bracket (for Lower Side).


Hide 17410 10.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.
A395771

Disengage the 2 wire harness clamps.


b.

Disconnect the heated oxygen sensor (for Bank 2) connector.


c.
A370444

Remove the 2 nuts and front exhaust pipe assembly from the exhaust manifold assembly LH (TWC: Front Catalyst).


d.

Remove the gasket from the front exhaust pipe assembly.


Hide 89465 11.REMOVE HEATED OXYGEN SENSOR (for Bank 2)